Exam Code : 4A0-M01
Exam Name : Alcatel-Lucent IP/MPLS Mobile Backhaul Transport
Vendor Name :
"Alcatel-Lucent"
4A0-M01 Dumps
4A0-M01 Braindumps 4A0-M01 Real Questions 4A0-M01 Practice Test
4A0-M01 Actual Questions
killexams.com Alcatel-Lucent 4A0-M01
Alcatel-Lucent IP/MPLS Mobile Backhaul Transport
https://killexams.com/pass4sure/exam-detail/4A0-M01
Click on the exhibit.
Each numbered item, 1, 2, 3, and 4, represents a message exchanged between an IEEE 1588v2/Precision Time Protocol (PTP) v2 master and slave. With which message does the master pass its t1 timestamp to the slave clock at item 2?
Announce
Delay_request
Delay_response
Sync
Click on the exhibit.
You wish to configure a preferred and a secondary static route on CSA1. targeting the MLS1 system interface. The preferred route must forward packets over the preferred route path as shown in the diagram. Given the following:
BFD must be enabled on the preferred route
BFD is configured on the interfaces
The BFD interface transmit and receiver timers are 500 ms
The BFD interface multiplier is 3
The CSA1 router must choose the preferred route in normal operations
Which command example correctly configures the PREFERRED static route on CSA1?
configure router static-route 192 0.2.0/32 next-hop 192.0.2.0 bfd-enable
configure router static-route 192.0.2.0/32 next-hop 192.0.2.5 bfd-enable
configure router static-route 192.0.2.5/30 next-hop 192.0.2.5 500 receive 500 multiplier 3
configure router static-route 192.0.2.0/32 next-hop 192.0.2.13 bfd-enable precedence 10
Click on the exhibit.
Given the configuration shown, and the following condition:
The next hop interface on the preferred path to prefix 192.0.2.0/32 failed
Label Distribution Protocol (LDP) is enabled on the interfaces
How long does the router wait before it moves traffic to the secondary route for this prefix?
900 ms
1.5 seconds
45 seconds
60 seconds
Click on the exhibit
Given the diagram and the following information:
Virtual Private Routed Network (VPRN) 5 spans the routers Point of Concentration (POC) 3-1 and 3-2 and the Multilevel Switch (MLS) routers MLS1 and MLS2
Multiprotocol Border Gateway Protocol (MP-BGP) is configured and operational
Pseudowire status is signaled, as shown, on the ePipe/VPRN spoke Service Distribution Points (SDPs)
What might you configure on the services illustrated to hold down the primary VPRN NodeB loopback interface static route in case of an intermittent or rapid spoke SDP failure and recovery?
Set port hold down timers on the CSA to POC3-1 link
Configure Label Distribution Protocol (LDP) Sync on the VPRN static routes
Enable BGP next-hop tracking in the VPRN BGP peer groups
SetareverttimervalueontheCSAePipe50endpoint
Which three are components found in the backhaul transport Mobile Telephone Switching Office (MTSO) functional area? (Choose 3)
2G Base Station Transceiver (BTS)
LTE Radio Network Controller (RNC)
EV-DO Radio Network Controller (RNC)
MSP Aggregation Gateway (MG)
GSM Base Station Controller (BSC)
Ethernet over SONET (EoS) UNI
In a Mobile Service Provider (MSP) network, which device aggregates traffic for delivery to the control elements?
BTP Aggregation Gateway (BG)
BTP Termination Device (BT)
MSP Aggregation Gateway (MG)
MSP Termination Device (MT)
Click on the exhibit.
Given the topology shown:
Which Border Gateway Protocol (BGP) feature must be configured on MLS1 and MLS2 to allow them to act as iBGP route reflectors?
BGP peer tracking
Cluster IDs
BGP Route Reflection
Autonomous System (AS) Number
Which statement describes an instance where a control word would be required in an aPipe service?
ATM cell mode is used to map multiple virtual circuits into a single aPipe service
The aPipe service transports concatenated cells from an entire virtual path
The service carries just the cell payload and Equal Cost Multipath (ECMP) is used in the transport
A cell mode service must map different ATM virtual circuits to a service based on Quality of Service (QoS) profiles
The 3rd Generation Partnership Project (3GPP) wireless standards cover which three technologies? (Choose three.)
2G Global Systems for Mobile (GSM)
2G Code Division Multiple Access (CDMA)
3G Universal Mobile Telecommunications System (UMTS)
3G Evolution-Data Optimized (EV-DO)
4G Long Term Evolution (LTE)
3G High Rate Packet Data (HRPD)
Click on the exhibit.
Given the following:
On the OC-3 port, each provisioned channel group contains all available timeslots. The command result illustrates which OC-3 port characteristic?
On STS1-3,the second DS1 channel group in the fourth VTG is set for atm encapsulation
On STS1-3, the second E1 channelgroup in the fourth VTG uses onlythe first 24 timeslots
On STS1 -3, the second DS1 channel group i n the fourth TUG-2 is set for 32 timeslots
On STS1-3, the second VT2 in the fourth TUG-2 is set for atm encapsulation
Click on the exhibit.
Given the topology shown:
Which timing solution would deliver time of day information to the NodeB connected lo the ATM/IMA link labeled 4 in the diagram?
TDM Line Timing
Adaptive clock recovery (ACR)
Synchronous Ethernet
Global Positioning System (GPS)
Click on the exhibit.
Which condition would cause the bundle Oper Status: shown?
The bundle local and remote peer endpoint discriminators are mismatched
The bundle remote peer Layer 3 (L3) interface is down
The local and remote bundle MRRU values are mismatched
The ML-PPP bundle member links have dropped below the minimum threshold