Exam Code : CWAP-404
Exam Name : Certified Wireless Analysis Professional (CWAP) Certification
Vendor Name :
"CWNP"
CWAP-404 Dumps CWAP-404 Braindumps
CWAP-404 Real Questions CWAP-404 Practice Test CWAP-404 Actual Questions
killexams.com
Certified Wireless Analysis Professional (CWAP) Certification
https://killexams.com/pass4sure/exam-detail/CWAP-404
When configuring a long term, forensic packet capture and saving all packets to disk which of the following is not a consideration?
Total capture storage space
Individual trace file size
Real-time packet decodes
Analyzer location
You are performing a multiple adapter channel aggregation capture to troubleshoot a VoIP roaming problem and would like to measure the roaming time from the last VoIP packet sent on the old APâs channel to the first VoIP packet sent on the new APâs channel.
Which timing column in the packet view would measure this for you?
Delta
Absolute
Roaming
Relative
Protocol analyzers may present field values in either binary, decimal or hexadecimal.
What precedes a
hexadecimal value to indicate it is hexadecimal?
0x
%
HEX
16x
Which one of the these is the most important in the WLAN troubleshooting methodology among those listed?
Interview the network manager about the issues being experienced
Talk to the end users about their experiences
Observe the problem
Obtain detailed knowledge of the wireless vendors debug and logging options
The network administrator at ABC Engineering has taken a large packet capture from one of their APs running in monitor mode. She has very little knowledge of 802.11 protocols but would like to use the capture file to evaluate the overall health and performance of their wireless network. When she asks your advice, which tool do you recommend she opens the packet capture file with?
Capture visualization tool
Protocol analyzer
Spectrum analyzer
WLAN scanner
802.11k Neighbor Requests and Neighbor Reports are sent in what type of Management Frames?
RRM
Action
Beacon
Reassociation Request and Reassociation Response
Which one of the following is required for Wi-Fi integration in laptop-based Spectrum Analyzer software?
A supported WLAN adaptor with a customized driver
Any 802.11 wireless adaptor
A dual radio spectrum analyzer card
SNMP read credentials to the WLAN controller or APs
Youâre the WLAN administrator for a large retailer based at the HQ in New York. The London-based office has been complaining about WLAN disconnections around lunch time each day. You suspect this might be interference from
the staff microwave, how might you test your theory from the New York office?
Access the microwave remotely and run a diagnostic check
Ask a local member of staff to take some pictures of the microwave, including some close-ups of the door seal so that you can access it
Place one of the London APs into spectrum analyzer mode and monitor the situation over lunch time
Ask a local member of staff to change the frequency of the microwave and see if the disconnections stop
ABC International has installed a new smart ZigBee controlled lighting system.
However, the network team is concerned that this new system will interface with the existing WLAN and has asked you to investigate the impact of the two systems operating simultaneously in the 2.4 GHz band. When performing Spectrum Analysis, which question could you answer by looking at the FFT plot?
Do the ZigBee channels used by the lightning system overlap with the WLAN channels?
Is the ZigBee system using more the 50% of the available airtime?
Is the ZigBee system causing an increase in WLAN retries?
Is the WLAN corrupting ZigBee system messages?
In a Spectrum Analyzer the Swept Spectrogram plot displays what information?
The RF time domain
RF power present at a particular frequency over the course of time
Wi-Fi Device information
Duty cycle in the frequency domain
You have installed a new 802.11ac WLAN configured with 80 MHz channels. Users in one area are complaining about poor performance. This area is currently served by a single AP. You take a spectrum analysis capture in the poor performing areA. While examining the waterfall plot you notice the airtime utilization is higher on the first 20 MHz of the 80 MHz channel when compared to the rest of the channel. What do you conclude?
The AP is misconfigured and needs to be reconfigured to 80MHz operation
RRM is enabled and has dynamically picked a 20 MHz channel
The first 20 MHz is the APâs primary channel and higher airtime utilization on the primary channel is normal when an AP Is configured for 80 MHz operation
Non Wi-Fi interference is preventing the APs 80 MHz operation
Which common feature of a Spectrum Analyzer would be the best to help you locate a non-802.11 interference source?
Max hold
Location filter
Waterfall plot
Device finder
A manufacturing facility has installed a new automation system which incorporates an 802.11 wireless network. The automation system is controlled from tablet computers connected via the WLAN.
However, the automation system has not gone live due to problem with the tablets connecting to the WLAN. The WLAN vendor has been onsite to perform a survey and confirmed good primary and secondary coverage across the facility. As a CWAP you are called in to perform Spectrum Analysis to identify any interference sources. From the spectrum analysis, you did not identify any interference sources but were able to correctly identify the issue.
Which of the following issues did you identify from the spectrum analysis?
The tablets are entering power save mode and failing to wake up to receive the access points transmissions
A high noise floor has resulted in a SNR of less than 20%
The tablets are connecting to the wrong SSID
There is a power mismatch between the APs and the clients
Finish the statement. It is possible to distinguish between and 20 MHz transmissions when looking at an FFT plot.
HR/DSSS and ERP
ERP and VHT
HT and VHT
OFDM and HT
What is the function of the PMD sub-layer?
Converts 1s and 0s given to it by the PLCP sub-layer into the appropriate RF signals
Provides framing
Adds a PHY preamble and header to a PSDU
Performs A-MPDU
What is the function of the PHY Preamble?
To set the modulation method for the MPDU
Allows the receiver to detect and synchronize with the signal
To terminate a conversation between transmitter and receiver
Carries the NDP used in Transmit Beamforming and MU-MIMO