150-130 Dumps 150-130 Braindumps 150-130 Real Questions 150-130 Practice Test 150-130 dumps free Brocade 150-130 Brocade Certified Network Engineer 2012 http://killexams.com/pass4sure/exam-detail/150-130 QUESTION 111 Which three statements are true when configuring virtual routing interfaces? (Choose three.) A. A single virtual interface can be used to route traffic between all VLANs within the same switch. B. Each VLAN on a switch requires its own virtual interface. C. A virtual interface can be a member of multiple VLANs. D. A virtual interface can have multiple IP addresses. E. Hosts in a VLAN can use the IP address of the virtual interface as their default gateway. Correct Answer: BDE QUESTION 112 You are configuring multiple VLANs using only untagged ports on two switches. Which statement is true? A. All traffic between switches will use 802.lq. B. AII VLAN traffic can use a single untagged uplink port. C. Untagged ports can be placed into multiple VLANs. D. Each VLAN requires a dedicated uplink between switches. Correct Answer: D QUESTION 113 Which two statements about LAGs are true? (Choose two.) A. A LAG provides load-sharing. B. A LAG provides sub-microsecond failover, C. A LAG can contain links of different speeds. D. A LAG is treated as a single logical link by the switch. Correct Answer: AD QUESTION 114 Your company uses OSPF and has recently purchased another company that uses RIP. Management requires that routes between the two companies be shared without interrupting services on either network. How is this implemented? A. Enable route redistribution in both RIP and OSPF on the DR. B. Enable route redistribution in both RIP and OSPF on the BDR. C. Enable route redistribution in both RIP and OSPF on the ASBR. D. Enable route redistribution in both RIP and OSPF in the ABR. Correct Answer: C QUESTION 115 What are two valid BPDU types in Spanning Tree 802.1D? (Choose two.) A. Configuration BPDU B. Root Override BPDU C. Failure Notification BPDU D. Topology Change Notification BPDU Correct Answer: AD QUESTION 116 When using CIDR notation, what is the default route in an IPv6 configuration? A. ::/0 B. 1001:ffff:0:0:0:0::Vl28 C. 1001:ffff:0:0:0::y0 D. ffff::/36 Correct Answer: A answer is right. QUESTION 117 What are two Brocade stackable products? (Choose two.) A. Brocade Fastiron SX B. BrocadeFastIronCX C. BrocadelCX6430 D. Brocade MLXe Correct Answer: BC great answer. QUESTION 118 You have just configured a new Multi-Chassis Trunk between two Brocade MLXe chassis. Which protocol information will be distributed across this link? A. IPv6 B. BGP C. RIPv2 D. STP Correct Answer: D good answer. QUESTION 119 Which two statements about ingress extended ACLs are correct? (Choose two.) A. They use extended ACL IDs 200 - 299. B. They save network resources by reducing traffic. C. They eliminate denial of service (DoS) attacks. D. They block unwanted traffic or users. Correct Answer: BD QUESTION 120 Which statement is true of an access control list (ACL) on a Brocade IP device? A. Only outbound ACLs can be used on any Brocade IP device. B. The ACL takes effect immediately after being applied to an interface. C. An ACL is immediately applied to all physical interfaces once the ACL is configured. D. Standard ACLs can be used to control traffic inbound or outbound based on source and destination addresses. Correct Answer: B QUESTION 121 When 802.lp priority override is enabled on the primary port of a trunk group, which other ports of the trunk group will be affected? A. all ports except the primary trunk port B. some of the trunk ports C. only the primary port of the trunk group D. all ports of the trunk group Correct Answer: D QUESTION 122 What are the three available QoS scheduling algorithms available on Brocade NetIron and FastIron products? (Choose three.) A. weighted round robin B. strict priority C. first-in-first-out D. hybrid E. deficit round robin Correct Answer: ABD QUESTION 123 Which QoS mechanism would you use to set the DSCP value specified of an outgoing packet? A. dscp-cos-mapping B. dscp-matching C. dscp-marking D. internal-priority-marking Correct Answer: C QUESTION 124 sFlow uses which method to send data to a collector? A. multicast B. broadcast C. TCP port 6343 D. UDP port 6343 Correct Answer: D QUESTION 125 Given the command output shown below: de(config)#mirror-port ethernet 1/2/4 Brocade(config)#interface ethernet 1/2/11 Brocade(config-if-e100-11)#monitor ethernet 1/2/4 both What do the Brocade commands accomplish? A. They allow all traffic on interface ethernet 1/2/11 to be replicated on interface ethernet 1/2/4 for analysis B. They allow ingress only traffic on interface ethernet 1/2/4 to be replicated on interface Ethernet 1/2/11 for analysis. C. They allow all traffic on interface ethernet 1/2/4 to be replicated on interface ethernet 1/2/11 for analysis. D. They allow egress only traffic on interface ethernet 1/2/4 to be replicated on interface Ethernet 1/2/11 for analysis. Correct Answer: A For More exams visit https://killexams.com/vendors-exam-list Kill your exam at First Attempt....Guaranteed!